
VCC Cấp 5V
GND nối GND
SCK nối chân 18
MOSI nối chân 23
MISO Nối Chân 19
CS Nối chân 5 hoặc tùy chọn
Chương trình như sau
Chú ý trước file open text.txt Phải có "/"
Chương trình như sau cơ bản đọc ghi
/*
SD card read/write
This example shows how to read and write data to and from an SD card file
The circuit:
SD card attached to SPI bus as follows:
SS = 5;
MOSI = 23;
MISO = 19;
SCK = 18;
created Nov 2010
by David A. Mellis
modified 9 Apr 2012
by Tom Igoe
This example code is in the public domain.
*/
#include <SPI.h>
#include <SD.h>
#define CS 5
File myFile;
void setup() {
// Open serial communications and wait for port to open:
Serial.begin(9600);
while (!Serial) {
; // wait for serial port to connect. Needed for native USB port only
}
Serial.print("Initializing SD card...");
if (!SD.begin(CS)) {
Serial.println("initialization failed!");
while (1);
}
Serial.println("initialization done.");
SPI.setClockDivider(SPI_CLOCK_DIV128);
// open the file. note that only one file can be open at a time,
// so you have to close this one before opening another.
myFile = SD.open("/test.txt", FILE_WRITE);
// if the file opened okay, write to it:
if (myFile) {
Serial.print("Writing to test.txt...");
myFile.println("testing 1, 2, 3.");
// close the file:
myFile.close();
Serial.println("done.");
} else {
// if the file didn't open, print an error:
Serial.println("error opening test.txt");
}
// re-open the file for reading:
myFile = SD.open("/test.txt");
if (myFile) {
Serial.println("test.txt:");
// read from the file until there's nothing else in it:
while (myFile.available()) {
Serial.write(myFile.read());
}
// close the file:
myFile.close();
} else {
// if the file didn't open, print an error:
Serial.println("error opening test.txt");
}
}
void loop() {
// nothing happens after setup
}
Chú ý với file như sau myFile = SD.open("/test.txt"); không sẽ báo lỗi không mở được file
Các bạn tham khảo thêm tài liệu :https://www.mischianti.org/2021/03/28/how-to-use-sd-card-with-esp32-2/
Cảm ơn các bạn ghé thăm shop .